Lift Cable for Model WH-12SYM
SVI Part #: BH-7120-04
Cable for American Tire Distributors 2-Post Lift Model WH-12SYM
- Fits Model: American Tire Distributors 2-Post Lift Model WH-12SYM
- Overall Length: 32’ 10-1/4” (394.25 in / 10013.95 mm) Long
- Cable Diameter: 5/16” (7.938 mm)
- Cable Material: Galvanized Steel
- Cable Ends: (2) Threaded Studs 1/2”-13
- Fasteners Included
- Both Cable End Studs are threaded, with one end measuring 8-3/4” long including threads and the other end measuring 4-3/4” long including threads.
- For the American Tire Distributors WH-12SYM Lift Models, use the BH-7793-57 (Ref # 1-2715) Cable Assembly.
When measuring a worn cable, please consider deformation from stretching and use over time. It is always recommended that when replacing one cable, all cables should be replaced. Also consider sheaves, pulleys, shafts, pins, spacers, etc. It is also a good time to carefully inspect all other components including locking or safety devices. Never override safety devices or overlook safety in general.
- (1) Wire Rope Cable Assembly
- Fasteners Included
Alternative nomenclature or also known as:
- Wire Rope Balancing Cable
- Wire Rope Equalizing Cable
- Wire Rope Stabilizer Cable
- Wire Rope Synchronizing Cable
- Wire Rope Cable Assembly
- Wire Rope Cables
Uses: Auto Lifts, Car Lifts, Light Truck Lifts, Vehicle Lifts, Van Lifts, Bus Lifts
SVI is a premier, well-known expert supplier, and your best quality and cost option for replacement parts for American Tire Distributors Lifts. SVI is your answer!
Standard and Custom cables available. In-Stock Cables or repair parts ship same-day.
Safety First: Replace Auto Lift Cables at First Sign of Wear
All wire rope cables generally wear both from the inside and outside. Inside wear is much less significant and is caused as the cables are pulled across the cable pulleys or sheaves. This wear is caused by what is termed nicking and can appear on internal strands with an almost scalloped look. External wear on cables is much more apparent and is essentially abrasive wear. Abrasive wear is the result of metal being slowly worn away or removed over time. This appears on the crowns of each wire with a flattening of the wire appearance. As the wires flatten, material is being lost. Since the strength of the cable continues to lessen, the cable becomes weaker. Additionally, almost everyone at some point has seen frayed rope. This is a condition where unraveling, worn, or separated strands become evident. If this is observed to be happening on any wire rope cable assembly, immediately cease use of the equipment with this type of worn cable and replace the cable as well as the sheaves or pulleys immediately.
As a rule, if you own an auto lift or anything that uses wire rope cables, you should at a minimum conduct monthly visual inspection of the cables and sheaves or pulleys. This is especially important if your cable-driven equipment is frequently used. If you are starting to witness the small round strands comprising each cable assembly starting to flatten and then even flatter, it is time to consider replacing the affected cables. Most cables on auto lifts or even any equipment including winches are easy to replace and the costs are relatively minimal. If you do not wish to replace the cable assembly yourself, there are many companies that specialize in auto lift installation and service that can help you.
If you cannot locate an auto lift repair shop, Contact SVI and we will attempt to help you find someone in your area to properly replace your cables.